I have not plugged it into the scooter yet to test it.
waiting to get home to do that.

ok thats good know that that the write/flash seems to be good.

i'll test it tonight.

I got this error: Error: Init mode failed (unable to connect to target) All soldering is fine, and I try with 3 Dashboards.. Can anyone help me? are you able to see the telnet connection? any errors? in telnet type "usage" without the " and see if you get a response I got this message: C:\Users\Bad...

Guys. I figured out the Problem,, Ok so I was getting the exact error as the other guys. Turns out the ST Link Pin read out on the out metal casing is Incorrect/ different from the read out on the actual PBC board after I took it apart. the Grnd swdio and swclk wear not correct: So yeah it was DUE t...

The telnet command won't work yet because the previouse command didn't work.

It suppose to say: now accepting connections on telnet port 4444

But it just errors instead.

I think I got a lemon st link v2

What do you change the serial number to ?
Some randome number made up?
Or you get it from the metal or sticker on the scooter somewhere?

Unless the Pin Read out on my ST Link is backword or flipped.
Do they make manufactoruing mistakes on this little devices.

I have them exact same as the Pictures posted by the other guy here with the same issue.

i got all my software from this guide
I got my OSD from a broken abandoned jump scooter seway.

This is the OCD I'm using

OpenOCD:
http://www.freddiechopin.info/en/downlo ... ocd-0.10.0

I measure the volts at c9 cap, white everything is plugged in and only getting 2.4 volts

yeah, that sucks,
I was so exited, only to find the stupid error:

Error: Init mode failed (unable to connect to target)

Does the Dash need to be power on to the scooter, NO right. the 3.3 volts wlll power it on?

IDK, that sucks, thinkging about trying this on old windows 7 pc

Im getting the exact same error,
same circumstances, everything wired up ok

Error: init mode failed (unable to connect to the target)

Im on a windows 10 computer.

Did you find a resolution to your issue?