Search found 15 matches
- Sat Feb 29, 2020 2:51 am
- Forum: Ninebot Max
- Topic: Max dashboard BLE555 ST-Link guide (flash CFW)
- Replies: 26
- Views: 64107
Re: Max dashboard BLE555 ST-Link guide (flash CFW)
Just wanted to add some experience here. I just did this with an M365 Pro dash as well as a Ninebot Max dash from aliexpress and it worked on both. I will be posting a comprehensive tutorial on how to get one of these scooters working including BMS flash, dash flash, ESC flash, and using Ninebot Fla...
- Wed Feb 26, 2020 3:31 am
- Forum: Ninebot Max
- Topic: Ninebot Max ESC/DRV ST- Link - unbrick your Max ESC
- Replies: 9
- Views: 49274
Re: Ninebot Max ESC/DRV ST- Link - unbrick your Max ESC
Ok on one set of pictures I see the yellow wire that goes to the ST link going to the red and black wires do I hook them up to both the red and black wires at same time or just the red wire? Also on the other set of pictures the yellow wire that goes to the ST link it is somewhere on the board of t...
- Tue Feb 25, 2020 2:12 am
- Forum: Ninebot Max
- Topic: Ninebot Max ESC/DRV ST- Link - unbrick your Max ESC
- Replies: 9
- Views: 49274
Re: Ninebot Max ESC/DRV ST- Link - unbrick your Max ESC
I am connected to the ESC via ST Link but the addresses that I need to find do not exist.
- Mon Feb 24, 2020 11:48 pm
- Forum: Ninebot Max
- Topic: Lyft Ninebot G30 Pogress
- Replies: 18
- Views: 26272
Re: Lyft Ninebot G30 Pogress
Follow this thread: https://www.scooterhacking.org/forum/viewtopic.php?f=26&t=213 Also, apply power to the board from the ST-Link. I used the connector that ran from the BLE - third pin from the left which is where the red wire would plug into. I can't post pictures here. I hooked up the battery to...
- Sat Feb 22, 2020 9:45 pm
- Forum: Ninebot Max
- Topic: Lyft Ninebot G30 Pogress
- Replies: 18
- Views: 26272
Re: Lyft Ninebot G30 Pogress
Any luck figuring out how to flash the Lyft controller? I have mine connected with an ST link to the SWCLK, SWDIO, and GND pins with power coming from the scooter's battery. A small red LED is faintly illuminated on the controller but I am unable to connect to target.