Would there be a way to visually identify if the new Ninebot G65 Max 2 is hackable?
Posted: Sat Jan 21, 2023 6:46 pm
So I'm potentially getting a Max 2 as my Max is having issues and will be replaced (woo Australian Consumer Law!).
Obviously, I wanna install CFW. I have heard however that Ninebot has been progressively implementing encryption into these scooters to curb hacking, and having recently ridden a stock G30, I don't wanna go back.
From what I can see, the Max 2 is basically a G30P Gen 2 with a chassis and wheel diameter change (to the motor/wheels found on the F45), meaning there is a chance that the BMS, Control Board and Cockpit display are identical to previous models, opening up the possibility for hacking.
So, if I were to, say, open my G65 Max 2 and have a look at these components, would I be able to visually identify if there's any changes? Would someone well versed enough in this be willing to assist and take a look for me? I roughly know where these parts are located and how to get to them, but obviously I'd prefer to get at least somewhat of a blessing before I go ahead and load up CFW.
In addition, would there be any way to extract the firmware from the scooter? If I can, it might be worth it to the community if it can be compared to prior firmware revisions.
Obviously, I wanna install CFW. I have heard however that Ninebot has been progressively implementing encryption into these scooters to curb hacking, and having recently ridden a stock G30, I don't wanna go back.
From what I can see, the Max 2 is basically a G30P Gen 2 with a chassis and wheel diameter change (to the motor/wheels found on the F45), meaning there is a chance that the BMS, Control Board and Cockpit display are identical to previous models, opening up the possibility for hacking.
So, if I were to, say, open my G65 Max 2 and have a look at these components, would I be able to visually identify if there's any changes? Would someone well versed enough in this be willing to assist and take a look for me? I roughly know where these parts are located and how to get to them, but obviously I'd prefer to get at least somewhat of a blessing before I go ahead and load up CFW.
In addition, would there be any way to extract the firmware from the scooter? If I can, it might be worth it to the community if it can be compared to prior firmware revisions.