Re: Max dashboard BLE555 ST-Link guide (flash CFW)
Posted: Fri Jan 03, 2020 3:17 pm
Where is the C2 located on the G30D dashboard?
So I got C2 off cleanly. I connected the 3 wires as instructed - mind you mine is beeping with error 32 which I'm still trying to figure out means this can still be done - and I get this error:
Ninebot Max Dashboard Flasher - ScooterHacking.org
Waiting for flash to start...
Waiting for 0 seconds, press a key to continue ...
Flashing BLE555 Max firmware
Open On-Chip Debugger 0.10.0 (2019-02-10) [https://github.com/sysprogs/openocd]
Licensed under GNU GPL v2
For bug reports, read
WARNING: interface/stlink-v2.cfg is deprecated, please switch to interface/stlink.cfg
Info : auto-selecting first available session transport "hla_swd". To override use 'transport select <transport>'.
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
adapter speed: 1000 kHz
Info : clock speed 1000 kHz
Info : STLINK V2J29S7 (API v2) VID:PID 0483:3748
Info : Target voltage: 3.170428
Error: init mode failed (unable to connect to the target)
Done! Check the logs to verify if the flash was successful.
Press any key to continue . . ."
Cany anyone help?
Please post that tutorial. Im just banging head on the wall trying to get my Max G30 up and running again. Sucks error code 19.Just wanted to add some experience here. I just did this with an M365 Pro dash as well as a Ninebot Max dash from aliexpress and it worked on both. I will be posting a comprehensive tutorial on how to get one of these scooters working including BMS flash, dash flash, ESC flash, and using Ninebot Flasher to get things working with a custom firmware.