Re: Change Max serial number after DRV126 update
Posted: Thu Jan 02, 2020 2:05 am
Hello all and happy new year! Long time reader, first time poster in this forum, and would like to give a big thanks to everyone who make it possible for us to get our projects up n running.
Now to my reason for this post.
I was successful using the ESx swap to confirm via Segway app that indeed the serial #change has been made.
And also confirmed via ES Down G that DRV126(thats version 1.2.6 in the Segway app yes??) Is the current firmware. What I am not sure of is what the BMS and BLE versions should be.......currently BMS338 and BLE107 when I connect ES Down G with the ES dash. Displays the battery info as well.
Problem I ran into is that when I replace the original max dash(its a Spin Max btw), of which I did not perform a BLE555 flash, when I power up, the display flashes and goes black while beeping continuously until I decide to power it off. Only control I seem to have is the ability to turn on and off the headlight. Interesting sidenote; with the ES dash connected, I can control the light as well, but it is barely noticeable, as in very little lumens. It shows no error codes and no issues connecting to the Segway app and ES down G, have never been able to connect with the windows ninebot app so never attempted.
Have no other functionality with either dash. Any ideas what could be the issue for it not to run?
Any insight would be much appreciated, thanks!
Now to my reason for this post.
I was successful using the ESx swap to confirm via Segway app that indeed the serial #change has been made.
And also confirmed via ES Down G that DRV126(thats version 1.2.6 in the Segway app yes??) Is the current firmware. What I am not sure of is what the BMS and BLE versions should be.......currently BMS338 and BLE107 when I connect ES Down G with the ES dash. Displays the battery info as well.
Problem I ran into is that when I replace the original max dash(its a Spin Max btw), of which I did not perform a BLE555 flash, when I power up, the display flashes and goes black while beeping continuously until I decide to power it off. Only control I seem to have is the ability to turn on and off the headlight. Interesting sidenote; with the ES dash connected, I can control the light as well, but it is barely noticeable, as in very little lumens. It shows no error codes and no issues connecting to the Segway app and ES down G, have never been able to connect with the windows ninebot app so never attempted.
Have no other functionality with either dash. Any ideas what could be the issue for it not to run?
Any insight would be much appreciated, thanks!