Page 1 of 1

Successful BLE and ESC flash with SN# change BUT wont accelerate

Posted: Sat Jan 04, 2020 3:49 am
by Toot4Scoot
I wanted to get some insight on what could possibly causing my Max to not accelerate when pressing the speed lever.
Ran into problems at first, but eventually was able to flash BLE555 to the original dash, Flash DRV126(with version spoofing after default 126 took) changed the SN to the magic#, am able to connect via App and ESDown. Dash shows no error codes, can switch between modes and operate the headlight. Just wont go as if its not getting a signal from the lever control.

Any insight would be greatly appreciated! Thanks

Update: cant seem to post any photos. Failed a couple attempts