Problem with spin flashing
Problem with spin flashing
The problem is that when i connect the dashboard to my pc than its gos on and than off i need help
Re: Problem with spin flashing
in order to help you, you need to provide way more info. What steps have you tried? What are you trying to accomplish? do you have an st-link? What method are you trying to use to connect?
The more you tell us, the better we can help.
The more you tell us, the better we can help.
Re: Problem with spin flashing
So I connected the dashboard to the stlink as it says in the instructions for ble555 and removed the c2 from the back.
Then I connected the stlink to the pc and the dashboard lit up once and then went off again no connection.
All solder joints were firm
Then I connected the stlink to the pc and the dashboard lit up once and then went off again no connection.
All solder joints were firm
Re: Problem with spin flashing
Did you verify that your ST-link pin-out was the same on both the outer aluminum jacket and the pcb?
Depending on where you get your ST-link, the jacket could be mis-printed and to the unsuspecting user, will fail to yield any results.
I slide off the jacket and solder my wires directly to the pcb.
Hope this helps!
Depending on where you get your ST-link, the jacket could be mis-printed and to the unsuspecting user, will fail to yield any results.
I slide off the jacket and solder my wires directly to the pcb.
Hope this helps!
Re: Problem with spin flashing
So yes the pins were all correct and I also soldered them to the board but the g30d / p dashboard only turns on once and then off again
Re: Problem with spin flashing
When you say you removed the C2 capacitor from the back, don't you mean the one on the front? The cap you need to remove is on the same side as the display face.So yes the pins were all correct and I also soldered them to the board but the g30d / p dashboard only turns on once and then off again
Re: Problem with spin flashing
i too have experienced this issue everything is wired correctly i can connect it to the computer the dash comes on for a sec beeps once than turns off. st-link gives me an error "cant reset core". the videos i watch their dash stays on when connected to the computer im thinking the dash is locked down from flashing if you found a fix please let me know.
Who is online
Users browsing this forum: No registered users and 143 guests