I have used xiaoflasher a dozen times to flash custom firmware into my gen 1 G3OP with 1500 miles riden. Last time, I made a mistake and flashed firmware that included max speeds for Europe and Denmark. Afterwards, the dashboard began flashing a red 10 and will not turn off.
I have come to the conclusion that I need to solder in a ST link and reset my ESC. I've got an ST link and soldering tools.
My question is where do I connect the 5+ volt from the ST link? I have the ESC completely removed.
I have seen the video of how to flash the G30D but the solder points are in different locations.
Any advice would be much appreciated...
Connecting ST link to max
- meister_sd
- Posts: 31
- Joined: Mon Feb 24, 2020 4:29 am
Re: Connecting ST link to max
Red Circle
Re: Connecting ST link to max
So I had no luck soldering the st link to the esc. I ended up buying a new esc on amazon. After that I used nineflasher to reset the serial number. This fixed my scooter. I thought it was dead forever. So happy.
Who is online
Users browsing this forum: No registered users and 141 guests