I flashed the esc on my legally acquired lyft scooter, cannot get stvp to connect to the bms, so after reqiring the escfor the dash I hooked it up and was able to get it to power on by either jump starting the dash 5v and grd, or plugging the scooter in to avc. The BMS I couldn't flash because stvp wouldn't detect it, burnt out one bms trying. So I was hoping to be able to flash via ble, but since I'm using a cloned dash, the pinouts are on the back, and I notice the BLE555 has a bin for a cloneddash, but I'm not sure if that's valid for the one I have. I read one person bricked theirs by flashing from the bat file...
Any help appreciated. I'm sitting here with stlink hooked up to the dash but i'm concerned about frying it...
https://scootertalk.org/forum/viewtopic ... cc7ffb5900
that's the dash I have
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests