Page 1 of 1

No Charging Mode after region change

Posted: Wed Jul 07, 2021 3:03 pm
by Jann
Hi,

I'd like to have my G30D with cruise control (which does work only DRV126 and was removed due to german regulations) and a switchable light (which does work only using DRV154, because german regulations were misinterpreted in DRV126).
As a solution to have both, I use currently a CFW based on DRV154 and changed the region to EU/Global (and later US) - both have no regulations with lights and cruise control - they work just fine.
When charging the scooter recently, I noticed, that the scooter does not switch to charging mode. When I start charging, there is no beep - the scooter just keeps turned on (like without charging) and shuts off after some minutes. The charging mode keeps inactive and no battery percentage is shown. It looks kind of like I had selected "Remove Charging Mode" when creating the CFW but I did not - I've checked twice.

Summary:

Issue:
- "Remove Charging Mode" was NOT selected during CFW creation - but it behaves as if it has been activated
- only after I changed the region, not on stock G30D region
- tried with DRV126 and DRV154, same behavior
- no hardware modifications at all

DRV126/G30D:
Cruise control
Switchable light
Charging mode

DRV154/G30D:
Cruise control
Switchable light
Charging mode

DRV126 and DRV154/G30 and G30P:
Cruise control
Switchable light
Charging mode

DRV126 and DRV154/G30E
Cruise control
Switchable light
Charging mode

Wanted behavior (DRV154 preferred):
Cruise control
Switchable light
Charging mode

Does anybody has an idea to get my G30D to have a switchable light, cruise control and charging mode? Why does the charging mode not work, when having another region selected.

Thank you very much for your ideas
Jann

Re: No Charging Mode after region change

Posted: Fri Aug 20, 2021 11:06 pm
by lequarti
Hi,

I had the same issue after a long and methodic research.
This happens only with the G30E (gen2) models.
So, we must get the stock (vanilla) firmware of G30E II form segway/ninebot.
And the region changing procedure must be adjusted for these models.

Regards,
lequarti

Re: No Charging Mode after region change

Posted: Mon Aug 23, 2021 4:58 am
by lequarti
Hi,

** addition **

With ScooterHacking utility, in region change section, I found out G30E (new), I tried, and it restored the charging mode.
Hop it answers you question.
In reality, you may be want G30E within 30km/h, well, some workarounds have to be done i guess.
Best,
Lequarti

Re: No Charging Mode after region change

Posted: Thu Sep 09, 2021 8:37 am
by San505
Hi

So is there any soluciĆ³n to have cruise control and 30km/h on G30E II, and be able to charge it???

Best regards

Re: No Charging Mode after region change

Posted: Wed Sep 29, 2021 7:44 pm
by Sabrina221
If you are unable to find proper guidelines about your concern topic you may reach out recruit officer or supportive team to find the best solution. For more information this site can lead you to trustworthy source. I hope this proves a reliable source for you people.

Re: No Charging Mode after region change

Posted: Wed Oct 27, 2021 7:48 pm
by rankovicdejan
Hi,

I had the same issue after a long and methodic research.
This happens only with the G30E (gen2) models.
So, we must get the stock (vanilla) firmware of G30E II form segway/ninebot.
And the region changing procedure must be adjusted for these models.

Regards,
lequarti
How can i get this vanilla ? and after that how i change region for everything works fine (cruise control + charging + 25kmh max speed) ?