BMS UART protocol?

michaelc
Posts: 1
Joined: Sun Jan 19, 2020 4:33 pm

BMS UART protocol?

Postby michaelc Sun Jan 19, 2020 4:45 pm

HI guys,

Short Story: I'm looking for the commands & protocol to directly communicate with the battery BMS. I've searched the internet and tried a couple of things, but no luck yet. What bytes do I need to send to read/write the BMS registers.

Long story: I've gone through 2 Ninebots already. The first one burning out after a couple of weeks, only to wait for a repair so that Ninebot could send me a brand new one. I've had this one for a couple of months, but that motor controller burned out also. Since I'm an electronics student, I thought it would be a good project to actually start from scratch and design my own control board/interface using the existing battery. For that of course, I would like to read/write data using UART to the BMS.

Some things I think about doing: using a waterproof circular touchscreen io the led panel, using a nice display library. Display battery health, mA...; in detail. Maybe also integrating location services from Google... once you start using cortex A, possibilities are limitless. The most important: using high quality parts that don't burn out every x months!

If I don't figure out the BMS protocol, I will be forced to use my own battery cells and creating a custom BMS, which is possible; but these things cost money and I figured the TI ic that is used in the BMS is actually a great quality one. If I were to create my own cells though, I would place them in the bottom of the frame, trying to make the ES more stable.

anyone interested in helping?
thanks!! greetings from Belgium

Return to “Ninebot ES”

Who is online

Users browsing this forum: DoUbLeR and 2 guests