I tried to flash an ES2 board, double checked the wiring and looks correct, but when triying to run the program command i get an error:
Code: Select all
telnet localhost 4444
Trying 127.0.0.1...
Connected to localhost.
Escape character is '^]'.
Open On-Chip Debugger
>
>
> program full_BLE.bin
Could not find MEM-AP to control the core
Target not examined, reset NOT asserted!
embedded:startup.tcl:449: Error: ** Unable to reset target **
in procedure 'program'
in procedure 'program_error' called at file "embedded:startup.tcl", line 474
at file "embedded:startup.tcl", line 449
A quick search shows that this error may be due to some kind of write protection.
Does this mean it cannot be programmed or is there any procedure?