Cannot charge through control board
- kneedraggar
- Posts: 3
- Joined: Wed May 25, 2022 5:54 pm
Cannot charge through control board
I have an ES2 and I am able to connect the battery directly to the charger and it will charge to 42v. When I try to charge using the charging port (going through the control board) the charger stays green and does not show any watts being drawn through my kill-a-watt. There is also no recognition on the display of any charging happening. I can also run the motor while charging (not sure if this is normal). I've tested the continuity of the charging port and it's fine. Since I can get 42v on the battery I assume I don't have a bat BMS. Is this a wrong assumption. What else can I check to trace the problem?
Re: Cannot charge through control board
Check Z fuses on battery, and fuses on BMS.
Return to “Ninebot ES and E-series”
Who is online
Users browsing this forum: No registered users and 113 guests