Cannot charge through control board

kneedraggar
Posts: 3
Joined: Wed May 25, 2022 5:54 pm

Cannot charge through control board

Postby kneedraggar Wed May 25, 2022 6:05 pm

I have an ES2 and I am able to connect the battery directly to the charger and it will charge to 42v. When I try to charge using the charging port (going through the control board) the charger stays green and does not show any watts being drawn through my kill-a-watt. There is also no recognition on the display of any charging happening. I can also run the motor while charging (not sure if this is normal). I've tested the continuity of the charging port and it's fine. Since I can get 42v on the battery I assume I don't have a bat BMS. Is this a wrong assumption. What else can I check to trace the problem?
misiozol
Posts: 24
Joined: Mon Sep 27, 2021 4:04 pm

Re: Cannot charge through control board

Postby misiozol Sat Jul 02, 2022 10:27 am

Check Z fuses on battery, and fuses on BMS.

Return to “Ninebot ES and E-series”

Who is online

Users browsing this forum: No registered users and 35 guests