My eyes are good enough to solder those little bitty spots. I seen a tool that looked like a plexiglass pegboard that would hold probes on points of a circuit board does anyone know what Im talking about or know where I can get one? want to get my dashboard programmed.
Thanks
Alternate to soldering?
- wielandgeorg
- Posts: 17
- Joined: Wed Jun 12, 2019 7:32 pm
Re: Alternate to soldering?
Hi! I've flashed a dozen dashboards using the frame with needles instead of soldering. Way better solution IMO
https://www.amazon.com/Programmer-Farwa ... way&sr=8-1
Take care
https://www.amazon.com/Programmer-Farwa ... way&sr=8-1
Take care
- GermNScooter
- Posts: 1
- Joined: Sat Jul 27, 2019 4:00 pm
Re: Alternate to soldering?
For the dash you can use test clamps for SWD CLK and SWD IO. For 3v and ground you use the existing cables on the dash. No need to solder and probably cheaper than a plexiglass pegboard.
https://www.banggood.com/12Pcs-Test-Cla ... rehouse=CN
https://www.banggood.com/12Pcs-Test-Cla ... rehouse=CN
Return to “Ninebot ES and E-series”
Who is online
Users browsing this forum: No registered users and 55 guests