I'm sorry to go a bit off topic, but I am hoping you can help me as you have the same setup as me (ES2 with extenral pack). Trying to get past the 25km/h, but unsuccesful so far.Good afternoon all,
I am facing the same challenge with my ES2 + external battery pack.
The last config in cfw (1.3.9) is hacks in speed (38km/h), battery power 42000 and kers low. Alternative acceleration logarithm deactivated.
This morning I experienced a less brutal breaking than before, but speed was kind a like unstable. On the flat I got to 34km/h before the scooter slowed down in a quite soft manner. Downhill it braked to 32.
So any other experiences with a comparable config so far?
-ES2Lite but changed serial number to a ES2, format N2GTX1111C0077 >> Do you have similar SN format?
-Custom firmware 5.5.1 (1.5.1) with max speed 34KMH and motor power 49000
-BME v 141 >> Do you also have this BME version?
-BLE v 104
What I did so far:
1) Flashed with custom firmware with EGDOWNG v151 with speed 34km/h and motor power 49000
2) Changed the SN to a ES2 SN with windows app Ninebot Flasher -> I am getting 25km/h now with the external battery, as a standard ES4 should do.
3) Flashed the eBMS and the BMS with v141, which I downloaded from the scooterhacking website https://files.scooterhacking.org/esx/fw/bms/
4) Tried the CFW 139 with flashed eBMS and BMS 136, but also stuck at 25km/h. No difference.
When both batteries are fully charged, I am hitting 25-27km/h. I feel like the scooter wants to go higher but there is a slight automatic brake every now and then, preventing the scooter to go faster. It's like there is a software limit set at this speed. I even get 'pushed' a bit like in a rollercoast (brake-accelerate-brake-accelerate), however very very subtle, going from 25kmh to 26kmh, back to 25kmh, again to 26-27kmh, ...